The X-A220EVO monophonic power amplifier offers a power of 220W. Our technical mastery combined with the most “audiophile” possible design of our circuits allows us to achieve high-level performance at a competitive price.
The steel frames have an impeccable finish. The incorporation of the methacrylate facades enhances its successful aesthetics, while providing an important ergonomic dimension, thanks to an impressive vu meter. The interior distribution is rational and compartmentalized. This judicious arrangement of the different sub-assemblies is accompanied by a selection of quality components, soldered on separate PCBs and divided by function. The X-A220EVO owes its thickness to the heat sink of the generously sized power transistor.
The X-A220EVO has a 700 VA toroidal transformer. After rectification, four 10,000 µF/80 V capacitors smooth the direct current. An NE5532 op amp is shown on the input board with balanced and unbalanced switching. The amplifier can operate in two modes accessible via a switch: when the “High Bias” function is activated, the X-A220EVO operates in class A and then transitions to class AB if more power is required.
Characteristics:
- High-quality monophonic stage
- 700VA toroidal transformer
- Frequency response: 10Hz to 80kHz
- Distortion: Less than 0.08%
- Signal to noise ratio: Greater than 100dB
- Front VU meter with lighting regulator
- Audio input: 1 x stereo RCA and 1 x balanced XLR
- 12V input and output trigger sockets
- Measurements: (Depth x Height x Width in cm): 45 x 20 x 43
- Weight: 21 kilos
Price by unit.
